Advertisement
Install Drawer System cont...
( C )
Position the Corner Wing Assemblies from Step 2B over the corners of the Drawer as shown. Secure the
Assemblies to the Drawer using the remaining M6 x 20 Hex Bolts, M6 x 19 Flat Washers and M6 Spring
Washers.
(
)
Secure the middle D-ring mounts on the Drawer System to the D-rings fitted in Step 2H using a 60 mm C-
D
hook and Turn Buckle (Items 2, 11) each side. Secure the front D-Ring mounts to the tie down rings found
at the rear of the vehicle using the remaining Turn Buckles and two 37 mm C-hooks (Item 35) recieved
with SSDS201. Ensure the Wing Nut goes towards the top of the Drawer System. When tightening the Turn
Buckles ensure that the Drawer System remains centered left to right and 60 mm from the front. Once the
Drawer is secure in position tighten the Wing Nuts on the Turn Buckles and the Bolts securing the D-rings
to the Drawer System and the vehicle's load bay.
MIDDLE MOUNTINGS
REV_A02
37mm C-Hook
Ensure Wing
Nut at Top
FRONT MOUNTINGS
Ensure Wing
Nut at Top
8
60mm C-Hook
Advertisement
