Table of Contents
Advertisement
Stardrape White LED WhiteCloth
The Stardrape can be operated with a controller in control mode or without the controller in
stand-alone mode.
Control Panel
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign DMX fixture addresses, which is the first
channel with which the Stardrape will respond to the controller.
Please note, when you use the controller, the unit has 8 channels.
When using multiple Stardrapes, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Stardrape should be 1(001); the DMX address of the second
Stardrape should be 1+8=9 (009); the DMX address of the third Stardrape should be 9+8=17 (017), etc.
Please, be sure that you do not have any overlapping channels in order to control each Stardrape
correctly. If two or more Stardrapes are addressed similarly, they will work similarly.
Controlling:
After having addressed all Stardrape fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the Stardrape will automatically detect whether DMX 512 data is received or
not.
If there is no data received at the DMX-input, the "LED " on the control panel will not flash.
If not, the problem may be:
•
The XLR cable from the controller is not connected with the input of the Stardrape White LED
WhiteCloth.
•
The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Ordercode: 40461W
A) LED display
B)
MODE button
C) ENTER button
D) UP button
E)
DOWN button
14
Fig. 05
Advertisement
Table of Contents
