Table of Contents
Advertisement
Chapter 2 Preparations
13. See Chapter 2 (1.33 Attaching the air baffle) to attach the air baffle.
14. See Chapter 2 (1.34 Installing Top Cover) to attach the top cover of the server.
15. Please see Chapter 2 (2 Installation and Connection) in this manual to conduct installation and connection,
and turn the power supply ON.
Identifying processor type
The type of processor installed on the server is displayed simply on the POST. To view this information and
additional processor specifications follow the directions below
1.
Reboot the server.
The server restarts and the POST screen is displayed.
2.
Press <F9> key.
System utility screen appears.
3.
Select System Information > Processor Information.
More information about the processors installed on the server appears on the screen.
4.
Keep pressing <ESC> key until the main menu is displayed.
5.
The menu below will appear, select OK from the system utility and switch to boot mode.
Removal
To remove CPU, reverse the installation procedure.
Also follow the steps below if the CPU was removed.
Mount the protective cover to CPU socket.
Remove the additional fan unit.
Mount the fan blank cover.
74
Note
In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Do not remove any CPU unless it is failed.
Important
In case you take off the CPU but do not fit a protection cover or dummy
cover, the cooling effect declines and the device may break down.
Express5800/R120h-2M (3rd-Gen) User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
