Table of Contents
Advertisement
Chapter 2 Preparations
Installing the Tertiary Riser PCI Card
Read the following notes first.
Please prepare the following before installing the options.
Parts included in the option kit
To install the components, follow these steps.
1.
Back up all data in the server.
2.
See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
3.
Raise the screw handles at the top of riser card (Butterfly Riser) and turn them to the left 180 degrees. Then
hold both sides of cage and lift them upright to remove the cage.
4.
Remove the blank cover of riser card following the procedures shown for primary/ secondary riser.
5.
Install the PCI card and fix it in place by following the same procedure in the primary and secondary risers.
108
Important
When installing a PCI card, make sure the connector of the card fits the
connector of the riser card.
Note
Check the card type which respective riser card supports and the type of PCI
card to be installed.
Important
To prevent personal injury, electrical shock or equipment damage, unplug
the power cord and ensure no power is supplied to the server. You cannot
turn off the system power supply completely by the power button on the
front panel. Until the AC power cord is unplugged, the power supply circuit
is still active in some parts of the machine.
Note
When running a server, always ensure proper cooling by attaching the top
cover, baffle, expansion slot cover, and blank. If the server supports
components with hot-plug support, minimize the amount of time the top cover is
open.
Note
Keep each removed blank covers.
Important
Do not touch the terminal part of riser card or PCI card and the signal pins of
electric parts installed on the board. Installing boards with dirt or oil can
cause malfunction.
Express5800/R120h-2M (3rd-Gen) User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
