Table of Contents
Advertisement
Chapter 2 Preparations
5.
Align the LOM card pins to the LOM connector of the motherboard and insert it.
Tighten the screws firmly.
6.
Fit the terminal of riser card to the slot on the mother board and insert the terminal firmly into the slot. Then
fix the primary riser card. Second, raise the screw handles at the top of cage and turn them to the right 180
degrees to fix the cage. Then put down the screw handles as before.
7.
See Chapter 2 (1.34 Installing Top Cover) to attach the top cover of the server.
8.
Please see Chapter 2 (2 Installation and Connection) in this manual to conduct installation and connection,
and turn the power supply ON.
Removal
The procedure for removal is the reverse of installation.
Re-attach the blank cover if you operate without it attached.
Note
In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Important
To maintain the cooling effect in the server, install the blank cover in the
vacant LOM Card slot.
Express5800/R120h-2M (3rd-Gen) User's Guide
1. Installing Internal Optional Devices
131
Advertisement
Table of Contents
