Table of Contents
Advertisement
Chapter 3 Setup
(3)
The Warning pop-up shown below (*) is displayed, and iLO is restarted.
(*) The message may be slightly different.
(4)
Wait one minute with the Warning pop-up displayed.
Do not perform any operation while waiting.
(5)
After one or more minutes, check that the STATUS lamp on the front of the device illuminates in green.
(6)
After checking that the restart of iLO is completed, click OK.
(7)
Press the <ESC> key several times to return to the System Utilities screen.
(8)
Select "Reboot the System" of System Utilities to reboot.
□ Operation for the Question pop-up of Submit Fail For Form
When the Question pop-up of Submit Fail For Form as shown below is displayed while changing settings in
System Utilities, select Cancel to discard the change. After that, reboot the server, enter System Utilities, and
change the settings again.
238
Important
If you proceed without waiting for the completion of the restart of iLO, the
subsequent system reboot may not operate properly, or setting information
such as Serial Number and Product ID recorded in the device may be lost.
The operation status of iLO can be checked with the STATUS lamp on the front
of this product.
The STATUS lamp blinking in green (once per second) indicates that iLO is
being restarted. The STATUS lamp illuminating in green indicates that the
restart of iLO is completed and it is operating normally.
Important
If you click OK to proceed with the setting changes, the setting information
such as Serial Number and Product ID recorded in the device may be lost.
Express5800/R120h-2M (3rd-Gen) User's Guide
2. Description on System Utility
Advertisement
Table of Contents
