Setting The Primary Account Number; Setting The Secondary Phone Number; Setting The Secondary Account Number - Simplex Foundation Series Operation Manual

9.4.4

Setting the primary account number

To set the primary account number, complete the following steps:
1. See the Accessing the DACT program menu
2. Press ENTER and then press the UP and DOWN keys until [Pri Account #] is displayed.
<ENTER>=Accept
Opt: [Pri Account #]
Press ENTER. The control unit displays the following:
3.
Pri Account #
[0]000
4. Use the LEFT and RIGHT keys to move the cursor from one digit to another. Use the keypad numbers, or use the UP and DOWN
keys to enter each number. Press ENTER when the number is correctly entered. The control unit displays a prompt to confirm
the number that you entered.
Press ENTER. The prompt shown in Step 2 reappears.
5.
6. Press the DOWN key to move to the next option [Sec Phone #].
9.4.5

Setting the secondary phone number

To set the secondary phone number, complete the following steps:
1. See the Accessing the DACT program menu
2. Press ENTER and then press the UP and DOWN keys until [Sec Phone #] is displayed.
ENTER>=Accept
Opt: [Sec Phone #]
3. Press ENTER. The control unit displays the following:
Sec Phone #
[X]XXXXXXXXXXXXXXX
Use the LEFT and RIGHT keys to move the cursor from one digit to another.
4.
Use the keypad numbers, or use the UP and DOWN keys to enter each number.
Press ENTER when the number is correctly entered.
The control unit displays a prompt to confirm the number that you entered.
5. Press ENTER. The prompt shown in Step 2 reappears.
6. Press the DOWN key to move to next option [Sec Account #].
9.4.6

Setting the secondary account number

To set the secondary account number, complete the following steps:
1. See the Accessing the DACT program menu
2. Press ENTER and then press the UP and DOWN keys until [Sec Account #] is displayed.
<ENTER>=Accept
Opt: [Sec Account #]
3. Press ENTER. The control unit displays the following:
Sec Account #
[0]000
4. Use the LEFT and RIGHT keys to move the cursor from one digit to another. Use the keypad numbers, or use the UP and DOWN
keys to enter each number. Press ENTER when the number is correctly entered. The control unit displays a prompt to confirm
the number that you entered.
Press ENTER. The prompt shown in Step 2 reappears.
5.
6. Press the DOWN key to move to the next option [Dialing Mode].
page 32
2008 Foundation Series Fire Alarm Control Unit Operation Guide
section and repeat the steps from 1 to 4.
section and repeat the steps from 1 to 4.
section and repeat the steps from 1 to 4.
579-1401 Rev A