Drive cage
You must remove the drive cage to access the components underneath.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Disconnect the power and data cables from the rear of the drives in the drive cage.
5.
Press the release lever on the side of the drive cage (1), and then lift that side of the drive cage up (2).
6.
Remove the drive cage from the chassis (3).
To install the drive cage, reverse the removal procedure.
22
Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
18).
(Front bezel on page
19).
17).