Table of Contents
Advertisement
Option port board
For a list of available option port boards, see the
An option port board can be installed under the heat sink near the back of the system board that provides an
additional connector on the rear I/O panel.
To remove the option port board:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the fan
4.
Remove the heat sink
5.
Remove the two Phillips screws (1) that secure the board to the system board.
6.
Lift to disengage the board from the system board connector, and then remove the option board from
the computer (2).
To install the option port board, reverse the removal procedures.
46
Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
(Fan on page
40).
(Heat sink on page
41).
Computer major components on page
18).
4.
17).
Advertisement
Table of Contents
