Table of Contents
Advertisement
Card reader
The card reader is attached to the front of the computer.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the drive cage
5.
From the inside of the chassis, disconnect the card reader cable from the white system board labeled
SD RDR.
6.
Remove the screw that secures the card reader to the front of the computer (1), and then remove the card
reader from the computer (2).
To install the card reader, reverse the removal procedures.
48
Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
18).
(Front bezel on page
19).
(Drive cage on page
22).
17).
Advertisement
Table of Contents
Need help?
Do you have a question about the ProDesk 405 G4 Small Form Factor and is the answer not in the manual?