Drive cage
You must rotate the drive cage to the upright position to access components underneath it.
To rotate the drive cage:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Disconnect the power and data cables from the rear of the drives in the drive cage.
5.
Rotate the drive cage up.
6.
Rotate the drive cage down.
7.
Reconnect the power and data cables to the rear of the drives in the drive cage.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page
19).
18)
17)
Drive cage
27