Drive cage
The drive cage is located next to the heat sink. The drive cage is secured with three Phillips screws.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the hard drive
4.
Remove the three screws (1) securing the hard drive cage to the chassis.
5.
Lift the hard drive cage (2) out of the chassis.
6.
Pull the hood sensor (3) up and off the hard drive cage.
To install the drive cage, reverse the removal procedure.
(Preparation for disassembly on page
(Access panel on page
(Hard drive on page
23).
19).
18).
Drive cage
25