Drive cage
Follow these steps to remove the drive cage:
1.
Prepare the computer for disassembly (see
2.
Remove the access panel (see
3.
Disconnect all power cables and data cables from the hard drives installed in the drive cage (see
drives on page
4.
Press down on the drive cage release tab (1).
5.
Lift the right side of the drive cage (2) until it rests at an angle.
6.
Slide the drive cage (2) up and to the right at an angle and remove it.
Reverse this procedure to install the drive cage.
34
Chapter 4 Removal and replacement procedures
Access panel on page
32).
Preparation for disassembly on page
29).
28).
Hard