Install The Qfx10016 - Juniper QFX10016 Quick Start Manual

3. Using the lift, align the switch in front of the rack, centering it in front of the mounting brackets.
4. Lift the chassis approximately 0.75 in. (1.9 cm) above the surface of the mounting brackets. Align the chassis as close
as possible to the mounting brackets.
5. Carefully slide the chassis onto the adjustable mounting brackets until the front-mounting brackets attached to the
chassis contact the rack rails. The mounting brackets ensure that the holes in the front-mounting brackets align with
the holes in the rack rails.
6. Move the lift away from the rack.
7. Install a mounting screw into each of the open front-mounting holes aligned with the rack, starting from the bottom.
8. Visually inspect the alignment of the switch. If the switch is installed properly in the rack, all the mounting screws on
one side of the rack are aligned with the mounting screws on the opposite side and the switch is level.
9. After ensuring that the switch is aligned properly, tighten the screws.

Install the QFX10016

IN THIS SECTION
What's in the Box? | 8
What Else Do I Need? | 8
7