Fast Track To Rack Installation And Power; Install The Srx1600 In A Rack - Juniper SRX1600 Hardware Manual

Fast Track to Rack Installation and Power

SUMMARY
This procedure guides you through the simplest
steps to install your SRX1600 Firewall in a rack and
connect it to power. Have more complex installation
"Install the SRX1600 in a Rack" on
needs? See
page 45
.

Install the SRX1600 in a Rack

You can install the SRX1600 Firewall in a four-post rack or cabinet. We'll walk you through the steps to
install an AC-powered firewall in a square-hole four-post rack.
Before you install, review the following:
• "SRX1600 Site Guidelines and Requirements" on page 33
• General Safety Guidelines and
• "Unpack the SRX1600" on page 43
1. Wrap and fasten one end of the electrostatic discharge (ESD) cable grounding strap around your bare
wrist, and connect the other end to a site ESD point.
2. Attach the side-mounting brackets to the chassis. Align the keyholes of the mounting brackets over
the shoulder screws of the chassis and slide the mounting brackets towards the rear of the chassis.
3. Assemble the mounting rails by sliding the rear rails into the front rails.
IN THIS SECTION
Warnings.
.
Install the SRX1600 in a Rack | 2
Connect to Power | 4
.
2