Install The Ssr1400 In A Rack - Juniper SSR1400 Hardware Manual

Table 12: Parts List for a Fully Configured SSR1400
Component
Rack mount kit
Part number: JNP-RMK-SSRHE
RJ-45 to USB A serial cable
Documentation Roadmap

Install the SSR1400 in a Rack

You can install an SSR1400 appliance into a four-post rack or a cabinet.
Complete these prerequisites before you install the appliance:
• Prepare the site for installation as described in
• Be sure the site has adequate clearance for both airflow and hardware maintenance, as described in
"SSR1400 Site Guidelines and Requirements" on page
• Unpack the appliance as described in
Ensure that you have the Phillips (+) screwdriver, number 2.
NOTE: Installing the chassis in a rack requires two people: one person lifts the chassis while the
other secures it to the rack.
(Continued)
Quality
•
2 front mounting brackets
•
2 side mounting rails
•
2 rear mounting blades
•
6 M4 flat-head screws (for the front mounting
brackets)
•
10 rack screws and cage nuts
•
2 M3 flat-head screws
1
1
"Site Preparation Checklist for SSR1400" on page
16.
"Unpack an SSR1400" on page 25.
27
15.