Fluke Versiv Series User Manual page 98

Versiv Series Cabling Certification Product Family
Users Manual
86
Find Quality Products Online at:
Table 5. Remote Requirements for Coaxial Tests
Test
HDTDR Optional. Without a remote, the plot shows large
analyzer reflections at the end of the cabling.
Resistance A remote or a terminator is required for a loop resistance
measurement.
Length Not required.
Because a coaxial cable terminator eliminates signal
reflections, the tester cannot measure the length of
terminated cabling. The tester shows End not found in this
case.
Impedance Optional.
Without a remote or terminator, the tester cannot measure
the impedance of cables longer than 984 ft (300 m). The
tester shows Unknown in this case.
Propagation Not required.
delay
Because a coaxial cable terminator eliminates signal
reflections, the tester cannot measure the propagation
delay of terminated cabling. In this case, the tester shows
End not found.
Insertion Loss Required.
* If a remote is not required for a test, the test runs without activating the toner
when no remote is detected.
GlobalTestSupply
www.
Remote Requirements*
.com
sales@GlobalTestSupply.com