Fluke Versiv Series User Manual page 161

Find Quality Products Online at:
On the TEST SETUP screen, tap the panels to change settings
3
for the test. See Table 7.
On the TEST SETUP screen, tap SAVE when your test setup is
4
completed.
On the CHANGE TEST screen, make sure the button next to
5
the test is selected, then tap USE SELECTED.
Table 7. Settings for Fiber Tests
Setting
Module
Select the CertiFiber Pro module you will use.
Test Type Use Smart Remote mode for tests on duplex-fiber cabling.
See page 158.
Use Loopback mode for tests on patch cords and cable
spools. See page 166.
Use Far End Source mode for tests on individual fibers. See
page 174.
Bi-directional Off: The tester does fiber tests in only one direction.
On: The tester does fiber tests in both directions. See "Bi-
directional Tests" on page 185.
The Bi-directional setting is not available for Far End Source
mode.
Fiber Type Select a fiber type that is correct for the type you will test.
To see a different group of fiber types, tap MORE, then tap
a group. To make a custom fiber type, tap Custom in the
Fiber Groups list. See the Technical Reference Handbook.
Fiber Type IOR: The tester uses the index of refraction to calculate the
Settings optical length of the fiber. Each fiber type includes the
value specified by the manufacturer. To use a different IOR,
make a custom fiber type. See the Technical Reference
Handbook.
GlobalTestSupply
www.
Certify Fiber Cabling
Settings for Fiber Tests
Description
(continued)
.com
sales@GlobalTestSupply.com
151