Fluke Versiv Series User Manual page 187

Find Quality Products Online at:
Make the connections to set the reference as shown on the
1-7
screen, then tap NEXT to see the completed connections.
Figure 67 also shows the completed connections.
The SET REFERENCE screen shows reference
connections for the selected reference method.
Figure 67 shows connections for the 1 Jumper
reference.
When you set the reference, keep the fiber as
straight as possible.
Turn on the optical source. On the CertiFiber Pro remote
1-8
module, hold down the button adjacent to the VFL port for 3
seconds to turn on the multimode source. See 68.
On CFP-QUAD modules, to turn on the single-mode source,
press the button again.
The CertiFiber Pro module in the remote always
operates in auto wavelength mode. The output
port transmits both wavelengths (850 nm and
1300 nm or 1310 nm and 1550 nm). The signal
includes identifiers that tell the main tester when
to measure power at each wavelength.
GlobalTestSupply
www.
Certify Fiber Cabling
Autotest in Far End Source Mode
Note
Note
Note
.com
177
sales@GlobalTestSupply.com