Auger Brazing - Chore-Time REVOLUTION Installation And Operator's Manual

Adult Turkey Feeder, MODEL ATF™ Feeder Line Assembly and Suspension

Auger Brazing

The auger should be brazed if it is necessary to splice or lengthen it. A bronze, flux coated rod is recommended.
The ends of the auger should butt against each other, NOT THREAD INSIDE EACH OTHER. See Figure 35.
The joint should be well filled with no sharp edges or tough corners to ware against the tube. To align the auger
for brazing, lay it in angle or channel iron and clamp it firmly in place. Use low heat. Allow the joint to air cool;
rapid cooling will cause the auger to become brittle.
Figure 35. Auger Brazing
27
MF232Q