Table of Contents
Advertisement
Installation
Connection to compressed
air supply
If earth continuity is not assured, check terminal, wire, bracket,
and grounding point.
Never operate the pump without having solved this problem.
Set the pressure at the air regulator.
For proper operation and long life of the engine, the supply air must be
filtered and not lubricated (see § Maintenance).
It is imperative to install a decompression valve after the
air regulator and as close as possible to the engine inlet
in order to follow the decompression procedure (See the
pump manual § Operating problems).
The engine air supply hose must have an inside diameter
of at least 19 mm.
The engines are tested before shipping. Nevertheless,
before coupling the motor to a pump, it is necessary to
operate it under vacuum at a pressure of 1 bar / 14.5 psi
maximum for a few minutes.
Proceed as follows:
Couple the motor with the recommended pump.
Connect the main air supply to the motor.
50
Advertisement
Table of Contents
