Table of Contents
Advertisement
8 Installation
Pump
Connections subsets
Motor – fluid section
Grounding
The pumps are designed to be installed in a paint booth or outside.
These fluid sections are intended to be coupled to pneumatic motors
compatible stroke.
It is imperative to comply with a motor / fluid section combination
provided by SAMES KREMLIN.
Coupled with a pneumatic motor, the fluid section will be
grounded via the earth cable of this motor.
This ground cable must be connected to a safe ground.
Loosen the lock nut (A), remove the washer (B), insert the
terminal (C) with its ground wire (min. Section: 1.5 mm2)
between the washer (B) and the washer (D).
Retighten the lock nut. Connect the other end of the wire to a
real "earth" that complies with the regulations of the country
concerned.
Have the earth continuity checked by a qualified electrician.
Installation
49
Advertisement
Table of Contents
