Table of Contents
Advertisement
Install the Access Point on a Pole Using KT-147407-02
Bracket Parts and KT-150173-01 Extension Arm
2. Attach the KT-147407-02 pole part to the 1-axis tilt bracket using two M12 bolts
through the large bracket holes on the 1-axis tilt bracket and the pole bracket.
3. Fasten the bolts using two M12 hex nuts.
4. Insert 0.5 in. stainless-steel cable clamp through the long slots on the pole bracket.
5. Position the cable clamps on the pole bracket around a pole and attach the pole
bracket.
6. Insert the ends of the cable clamps around the pole and tighten the clamp screws to
a torque of 11 in-lbs.
Install the Access Point on a Pole Using KT-147407-02 Bracket Parts and KT-150173-01
Extension Arm
Before You Begin
The following hardware is required for pole installation using KT-147407-02 bracket
parts and KT-150173-01 extension arm:
•
Flat part of the KT-147407-02 bracket
•
1-axis tilt part of the KT-147407-02 bracket
•
Pole part of the KT-147407-02 bracket
•
KT-150173-01 extension arm
•
Six M6 screws
•
Four hex-head M12 stainless-steel screws
•
Four hex-head M12 stainless-steel nuts
•
Two 0.5" wide stainless-steel cable clamps
•
One access point
About This Task
Install the access point on a pole with all three KT-147407-02 bracket parts and
KT-150173-01 extension arm
Procedure
1. Attach the flat part and the 1-axis tilt part of the KT-147407-02 bracket to the access
point.
For instructions on how to attach the bracket parts, see
1-axis tilt part of the KT-147407-02 bracket to the access
2. Align the circular holes on one end of the KT-150173-01 extension arm against the
large holes on the 1-axis tilt bracket.
3. Attach the KT-150173-01 extension arm to the 1-axis tilt bracket by using two hex-
head M12 stainless-steel screws and two hex-head M12 stainless-steel nuts.
4. Attach the KT-147407-02 pole part to the other end of the KT-150173-01 extension arm
using two M12 screws and M12 hex-nuts.
5. Insert 0.5 in. stainless-steel cable clamps through the KT-147407-02 pole part long
slots.
6. Position the cable clamps around a pole and attach the pole bracket to a pole.
32
ExtremeWireless™ AP560h Access Point
Install the Access Point
Attach the flat part and the
point.
Advertisement
Table of Contents
