Extreme Networks ExtremeWireless AP560h Installation Manual page 18

Install the Access Point on a Wall
Other wall install options include using the:
•
MBO-ART03 bracket
The following hardware is required when installing the access point on a flat surface
using the KT-147407-02 bracket:
•
One access point
•
Flat part of the KT-147407-02 bracket with two holes on the metal surface (see
part of the KT-147407-02
•
1-axis tilt bracket (see
•
KT-150173-01 extension arm (see
•
Six M6 screws
•
Four M6 size hex-head screws
•
Screw-in anchors if the access point is being mounted on a wood wall or a concrete
surface.
Note
The M6 hex-head screws and screw-in anchors must be provided by the
installer.
If you install the access point to the wall using the ART03 bracket, use the following
hardware:
•
One access point
•
MBO-ART03 articulating mounting bracket
•
Six M6 hex-head screws
Two M6 hex-head screws to attach the bracket to the access point
◦
Four M6 hex-head screws to attach the bracket to the wall or a flat surface.
◦
Note
The cable glands must face down when you install the access point on a wall.
18 ExtremeWireless™ AP560h Access Point
Note
You can use the MBO-ART02 bracket if you have one.
The MBO-ART02 wall mount bracket is End of Sale (EOS) as of January, 2023.
It is replaced by the MBO-ART03 bracket.
bracket).
Figure 6 on page 23).
Figure 7 on page 24).
Install the Access Point
Flat