Router Port - Edimax ECS1100 Series Web Management Manual

Router Port

VLAN ID for IGMP Snooping — Selects the VLAN which is to propagate all

multicast traffic coming from the attached multicast router.
Web Interface
To enable or disable IGMP:
1.
Click IGMP, then IGMP Snooping.
2.
Set the IGMP Snooping Setting to Enable.
3.
Select the VLAN on which IGMP Snooping will function.
4.
Click Apply.
Figure 30: Enabling IGMP Snooping
Use the IGMP > Router Port page to statically configure ports that are attached to
a multicast router/switch.
Usage Guidelines
Depending on network connections, IGMP snooping may not always be able to

locate the IGMP querier. Therefore, if the IGMP querier is a known multicast
router/switch connected over the network to port on the switch, the port (and a
specified VLAN) can be manually configured to join all the current multicast
groups supported by the attached router. This can ensure that multicast traffic is
passed to all the appropriate ports within the switch.
IGMP Snooping must be enabled on the switch before a multicast router port

can be configured.
Parameters
These parameters are displayed:
Port — Specifies a port attached to a multicast router.

– 49 –
Chapter 7
| IGMP Configuration
Router Port