Edimax ECS1100 Series Web Management Manual page 16

Chapter 2
| System Management
IP Settings
Parameters
The following parameters are displayed:
DHCP Setting — Specifies whether IP functionality is enabled via the Dynamic

Host Configuration Protocol (DHCP). If DHCP is enabled, IP will not function
until a reply has been received from the server. Requests will be broadcast
periodically by the switch for an IP address. DHCP responses can include the IP
address, subnet mask, and default gateway. (Default: Disabled)
IP Address — The IPv4 address assigned to the switch. (Default:

192.168.2.10)
Subnet Mask — The network mask that identifies the host address bits used for

routing to specific subnets. (Default: 255.255.255.0)
Gateway — The default gateway address for destinations not found in local

routing tables. (Default: None)
Web Interface
To configure a static IP address:
1.
Click System Management, then IP Settings.
2.
Leave the DHCP Settings as disabled.
3.
Enter an IPv4 address and subnet mask for the switch.
4.
Optionally enter an IPv4 address for the default gateway.
5.
Click Apply
Figure 5: Setting an IP Address
Note: If you change the IP address you will lose access to the web interface.
Restart a web interface session using the new configured IP address.
– 16 –