Port Configuration; Port Settings - Edimax ECS1100 Series Web Management Manual

3

Port Settings

Port Configuration

The port configuration pages are used to display or set communication parameters
for Ethernet ports, configure trunks, and set storm control or port speed limits.
This chapter describes the following topics:
Port Settings — Configures connection settings, including auto-negotiation, or

the manual setting of speed, duplex mode, and flow control.
Storm Control — Sets the traffic storm threshold for each port.

Port Speed Limit — Sets input and output rate limits for each port.

Port Trunk — Configures static trunks.

Port Statistics — Shows port statistics in table form.

SFP — Displays SFP transceiver information.

Use the Port Configuration > Port Settings page to enable/disable an interface, set
auto-negotiation, or manually fix the speed, duplex mode, and flow control.
Usage Guidelines
The Rate/Duplex mode is fixed at 1000M/Full for Gigabit transceivers and 100M/
Full for 100 Mbps transceivers.
Parameters
These parameters are displayed:
Port — The port number.

State — Allows you to manually disable an interface. You can disable an

interface due to abnormal behavior (e.g., excessive collisions), and then re-
enable it after the problem has been resolved. You may also disable an
interface for security reasons. (Default: Enabled)
Rate/Duplex — Allows auto-negotiation to be enabled/disabled. When auto-

negotiation is disabled, you can force the settings for speed and mode.
– 22 –