Unpacking; Uncrating - 3M -MATIC 8000a-T Instructions Manual

6-UNPACKING

6.1 Uncrating

The envelope attached to the shipping box contains
the uncrating instructions of the machine (Figure 6-1).
Cut straps. Cut out staple positions along the bottom
of the shipping box (or remove staples with an
appropriate tool - Figure 6-2).
After cutting out or removing the staples, lift the
shipping box in order to clear the machine
(two persons required).
Transport the machine with a fork-lift truck to the
operating position. Lift the pallet at the point indi-
cated in Figure 6-3 (weight of machine + pallet =
See Specifi cations).
8000a-8000a3 - NA
Figure 6-1
Figure 6-2
Figure 6-3
Removal of Pallet
Using a 10mm combination wrench, remove the
fasteners that secure the case sealer legs to pallet
at each leg (as shown in Figure 6-4).
Fasteners
Figure 6-4
Remove the leg height adjustment cap screws and
replace with the cap screws from the tool kit. Loosen
both cap screws. Remove and replace them one at
a time to keep the inner threaded plate in position.
A cardboard box is located under the machine body.
Retrieve the instruction manual for additional proce-
dures of the set up. The box also contains parts re-
moved for shipping, spare parts and tools (Figure 6-5).
6.2 Disposal of Packaging Materials
The 8000a-8000a3 package is composed of:
- Wooden pallet
- Cardboard shipping box
- Wooden supports
- Metal fi xing brackets
- PU foam protection
- PP plastic straps
- Dehydrating salts in bag
- Special bag of laminated polyester/aluminium/
Polyethylene (sea freight package only)
- Polyethylene protective material
For the disposal of the above materials, please follow
the environmental directives or the law in your country.
17
Figure 6-5
2014 June