Theory Of Operation; Emergency Stop - 3M -MATIC 8000a-T Instructions Manual

8-THEORY OF OPERATION

8.1 Description of the Working Cycle
After having closed the top fl aps of the carton,
the operator pushes it under the top infeed end in
order to avoid the opening of the top fl aps. Further
pushing causes the two bottom side belts to drive
the box through the taping heads which automatically
seal the top and bottom seams. The carton is then
expelled from machine belt drives.
8.2 Definition of Running Mode
The case sealer 8000a-8000a3 has only one (automatic)
operating mode with:
- The EMERGENCY STOP BUTTON unlocked
(Figure 8-1)
- Turn main start switch "ON" (I)
(Figure 8-2)
8.3.1 Normal Stop Procedure
When the main switch is OFF (O), the machine stops
immediately at any point of the working cycle. The same
thing happens in case of electrical failure or when the
machine is disconnected from the mains.

8.3.2 Emergency Stop

The LATCHING EMERGENCY STOP BUTTON is
located on the top center of the machine
(Figure 8-1).
8000a-8000a3 - NA
Figure 8-1
Figure 8-2
Figure 8-3
21
E-Stop Location
Belt Direction
2014 June