End Cycle; Temperature Options - Electrolux SkyLine PremiumS User Manual

Skip Preheating / Precooling
Touch the icon to skip this phase and go immediately to
the main cycle.
NOTE!
This phase can be enabled or disabled in F.17
SETTINGS chapter (Manual ⇨ General, ⇨ Cooking
preheating).
7. At the end of Preheating acoustic signals sound and the
door light flashes.
A pop-up window opens, showing the message that the
cycle can start.
1. If a TIME CYCLE is chosen: insert the food in the appliance
and close the door to start the cycle;
2. If the PROBE CYCLE is chosen: insert the food in the
appliance, the food probe in the product and close the door
to start the cycle;
MANUAL
Preheating done!
Insert the food into the cavity
and close the door to start the
Stop cycle
Hold down the button to stop the cycle.
160°C
00 29
00:30 h:m
F.6.6

END CYCLE

3. At the end of the cycle some acoustic signals sounds. A
pop-up window opens showing the summary of consump-
tion, time cycle and utility used.
N
Touch button to close the pop-up window;
Cycle done!
Now holding
The appliance starts holding.
22
cycle.
27
°C
:
:55
S
00:00:05
FSC
< 0.00 m³
< 0.001 KWh
< 1 l
Time consumption in hours : minutes : seconds
Utility used: FSC Food Safe Control
The final check by FSC is successful.
Utility used: FSC Food Safe Control
The final check by FSC is unsuccessful.
Gas consumption in m
Electric consumption in kWh
Water consumption in litres
F.6.7

TEMPERATURE OPTIONS

(for all cooking modes)
T
ECO DELTA
• This is an advanced cooking method, where the oven
compartment temperature varies according to the core
temperature of the food. The cavity temperature is automati-
cally adjusted according to the temperature inside the food
(CORE PROBE), maintaining a constant difference, "ECO-
DELTA" between them, from start to end of cooking.
Delta temperature
Values to be set:
This function enables cooking without harming the food with
high temperatures; this ensures more gentle and more even
cooking, with less weight loss.
The ECO-DELTA function is only possible with the core probe
inserted.
1. While setting the temperature, touch the icon
2. Enter the required delta value on the numeric keypad;
Touch button to confirm;
MANUAL
50
°C
1 2 3
4 5 6
7 8 9
0
T
3. Touch the probe icon
4. Insert the probe into the food (see the probe use at the
paragraph How to use a probe).
5. Close the door and press
3
from 5 to 120℃
T
;
MANUAL
1
30 %
30
°C
65
°C
and enter the required value;
button.