Electrolux SkyLine PremiumS User Manual page 72

Anom- Type of
Description
aly anomaly
ELMb Stops Detected a problem
cooking with the oxygen sensor
N°322
with
humidity
control (in
NORMAL
mode)
EntC Stops oven component compart-
ment NTC failure
N°290
(NTC1)
Eotd Warning High temperature on
water drain
N°251
Eprb1 Stops only Single point core
food probe probe failure
N°320
cycles
Epr6 Stops only Six points core probe
food probe failure
N°321
cycles
Ertc Warning Problem with internal
clock
N°1
ESCH Stops oven Component compart-
ment overtemperature
N°291
EStd Warning Water drain NTC
failure
N°253
Etb Stops Boiler safety thermo-
cycle/boiler stat trips.
N°220
Overtemperature in
the boiler.
72
Possible causes
• Lambda probe failure.
• Connector failure;
• TC sensor failure;
• ACU failure.
Possible lack of water in the
drain system.
• Food probe misuse (for
example, wire pulled or
squeezed);
• Connector failure;
• Probe failure;
• ACU failure.
• Food probe misuse (for
example, wire pulled or
squeezed);
• Connector failure;
• Probe failure;
• ACU failure.
Issue with hardware (for
example battery clock
exhausted).
• Filter is dirty;
• Too high room
temperature.
• Connector failure
• NTC sensor failure
• ACU failure
• Missing water in the
boiler;
• Limestone accumulation
in the boiler;
• Wrong insertion of the
TC probe sensor;
• The safety thermostat
bulb or the capillary are
damaged;
• Leakage of heat in the
safety thermostat body
area;
• The parameter BOT is
set too high;
• Room temperature <5°C.
Actions
It is possible to change the alerting mode of this
failure:
• NORMAL: the oven stops any cycle requiring
humidity control.
• ADVANCED: the alarm is a warning. The oven
keeps working in "Recovery mode." It is still
possible to run the cycles with possible non
optimal performances.
• HIDDEN: no alarm shown
To modify the alerting mode contact the Service.
Electronic board temperature sensor damaged.
• Cooking impossible.
• Call Service.
• Check that the oven has water supply;
• Pour some fresh water on the bottom cavity
filter; pay attention, do not splash hot cavity
with cold water as it could damage the
machine.
• If the problem persists call Service.
It is possible to run cycles based on time (without
food probe);
• If available, use the accessory USB food
probe;
• Call service to restore full functionality.
It is possible to run cycles based on time (without
food probe);
• If available, use the accessory USB food
probe;
• Call service to restore full functionality.
It is possible that some functionality do not work
(for example HCCP).
• Call Service.
• Check room temperature considering the
oven needs fresh air to cool electronic
compartment;
• Clean the filter;
• Allow oven to cool before cooking;
• Call Service if the problem reoccurs.
The oven continue to work.
• Call Service to fix the issue.
The oven is not able to produce steam with the
boiler. An alternative device will be used, but the
performance will be reduced;
• Call service to restore the boiler functionality.