Programs Mode - Electrolux SkyLine PremiumS User Manual

– If the FSC parameter is satisfied a recap message about
ending cycle pops up;
PRESET 1
FSC high risk guide
done
5.7 kWh
2 l
02:35:00
FSC
– If the FSC parameter is NOT satisfied a message warns
about the need to prolong the cycle until the food is in safe
conditions for its consumption.
F.7.3.10 Dehydration
DEHYDRATION
This cycle quickly dehydrates fruits, vegetables, meat and fish. It
eliminates the liquids from the food ingredients by making the
oven chamber dry thanks the highest air evacuation flow (up to
90 m 3 /h).
The oven works in manual mode with the only CONVECTION
cycle available with the vent OPEN.
AUTOMATIC
Cycles+
Low temper. Eco Delta Regeneration
cooking cooking
Static combi Proving Sous vide
Advance FSC FSC low risk FSC high risk
guide guide
Dehydratating Fresh pasta Smoker
pastorization
To set the Dehydration cycle proceed as follows:
• Set temperature (A), time (B) and speed fan (C);
• Touch button to start the cycle;
If the cavity temperature is lower or higher then the set
temperature the oven starts a cooling or a preheating phase.
• Once the set cavity temperature is reached, load the food into
the oven.
At the end of the cycle the display shows the consumptions (if
available) as a recap message.
It is possible to save and store the performed presets; see how to
manage them at Customized presets management paragraph of
this chapter.
F.7.3.11 Pasteurization of Pasta
PASTEURIZATION OF PASTA
This cycle is a special preset suitable for fresh pasta
pasteurization.
PRESET 1
1
50
%
100
°C
FSC
finishing
PRESET 1
1
Vent open
60
°C
A
100°C
01:30
:10
B
01:20 h:m
5
C
The oven works in manual mode with the only STEAM cycle
available.
AUTOMATIC
Cycles+
Low temper. Eco Delta Regeneration
cooking cooking
Static combi Proving Sous vide
Advance FSC FSC low risk FSC high risk
guide guide
Dehydratating Fresh pasta Smoker
pastorization
To set the cycle proceed as follows:
• Set the cavity temperature (A);
• Set the core probe temperature or the time (B);
• Touch button to start the cycle;
If the cavity temperature is lower or higher then the set
temperature the oven starts a cooling or a preheating phase.
• Once the set cavity temperature is reached, load the food into
the oven and the food core probe into the product.
At the end of the cycle the display shows the consumptions (if
available) as a recap message.
It is possible to save and store the performed presets; see how to
manage them at Customized presets management paragraph of
this chapter.
F.8

PROGRAMS MODE

The "Programs Mode" allows to recall program recipes already
stored or downloaded from cloud and/or create and store new
ones.
PRESET 1
1
100
°C
A
10
°C
25 °C
B
4
37