Update/Restore Automatic Cycles - Electrolux SkyLine PremiumS User Manual

9. After Sensing/Temperature recovery phases end, a screen
saver appears during the cycle.
It is possible to customize its view through the lower drawer.
Open it and choose the most suitable one.
01 04
01:20 h:m
Standard
view
6:30
PM
Standard view
Steps view
AUTOMATIC
150 °C
1
90 % 130
2
50 % 170 °C
130
99°C
10. At the end of the cycle the display shows the following
information:
Cooking done!
Now holding!
Time consumption in hours : minutes : seconds
HACCP
(recipe data stored into HACCP log)
Reference standard used (if enabled)
The check shows if the standard guide is successful.
Electric consumption in kWh
Water consumption in litres
:
: 50
Steps
view
220°C 20°C
94 °C 7
°C
7
99 °C
00:30:00
HACCP
FSC
5.7 kWh
2 l
F.7.2

UPDATE/RESTORE AUTOMATIC CYCLES

It is possible to update the automatic cycles stored in your oven
using an USB pendrive or, if needed, restore the previous cycles
before updating.
You can find the version of the automatic cookings stored in your
oven in the identity card page. See related paragraph F.17.21
IDENTITY CARD in "Settings" chapter.
UPDATE AUTOMATIC COOKINGS
Refer to Update automatic cookings paragraph in "Settings"
chapter and obey the following instructions:
1. Insert in the appropriate port the USB pen drive with the
automatics cookings UPDATE;
2. Select "Update Automatic cookings" command. The oven
searches for Automatic cookings in the USB pendrive.
SETTINGS
Automatic
Enable Automatic cooking
Enable step view
Factory presets
User presets
Food type
Cycles+
Update Automatic cookings
Restore Automatic mode
If the oven has found a new version of Automatic cookings, asks
for update confirmation.
SETTINGS
Automatic
A new version of Automatic
cookings was found: MM.mm.rr.
Do you want to update them?
Before the update it could be that:
• the USB pen drive is not inserted properly. Verify the USB
pendrive connection and select again the update of Automatic
cookings.
• the Automatic cooking files are not found. Verify that the USB
pendrive contains the updated cooking files.
• the Automatic cookings are not compatible with your software
version.
• the latest version of Automatic cookings is already installed.
There is no need to update them.
i
31