Start Options - Electrolux SkyLine PremiumS User Manual

Electrical and gas oven
Table of Contents

Advertisement

B. Set the starting time on the appearing keypad ("B") and
touch
to close it;
A
NOTE!
To cancel the delayed start, open the lower drawer
again and touch the green delay start icon. It should
change colour from green into white.
A. The display shows the set cooking cycle with the delayed
start. Touch the
button to confirm it ("C").
MANUAL
1
09 00
:
09:30
C
• If you want the oven to perform the preheating for the delayed
cycle, see F.17 SETTINGS chapter (Manual ⇨ General, ⇨ )
and enable the feature "Delayed start preheating" (
In this case the oven asks to perform the preparation phase
(preheating) for the cycle at the set time.
Preparation phase request
Do you want to perform the
preparation phase for this cycle?
The appliance starts the countdown. The display shows the
delay start icon, the remaining time and the set starting time.
MANUAL
09 3 : 0
AM
1 2 3
4 5 6
7 8
9
B
0
Delayed
start
5:30
100%
300°C
120°C
PM
01 30
:
:
50
09:30
/
).
It is still possible to skip the delay and start immediately the cycle.
In this case the oven starts the preheating phase.
F.6.5

START OPTIONS

Auto Start
Setting this option allows the cooking cycle to start by closing the
door. The START button is not visible on the display.
To enable the Autostart in all modes see F.17 SETTINGS chapter
(Autostart).
IMPORTANT
For regulatory requirements on gas appliances safety,
we suggest you to enable the Auto Start option
combined with the "Two touch" mode interface so as
to avoid any accidental start of the cycle.
Two Touch mode
When the cycle starts with the closing of the door (Autostart), the
"Two touch" mode forces the user to set and confirm the duration
of the cycle and thus become aware of the cycle being set.
MANUAL
1
50
%
160
°C
_ _ _ _
To enable the "Two Touch" mode contact an authorized
technician.
6.
The preheating (or precooling) phase starts. The preheat-
ing or precooling prepares the cavity temperature before
the beginning of the selected cycle.
MANUAL
1
70
%
250
°C
00:45
:00
NOTE!
If the cavity temperature is too high a message asks
for opening the door to facilitate its cooling down.
MANUAL
00:30
h:m
1
1 2 3
c
4
5
6
°
7
8
9
0
h:m
m:s
Preheating
250°C
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents