Forms Tear-Off Feature; Paper Park Feature - Genicom 930 User Manual

Forms Tear-Off Feature

Important! Never engage Forms Tear-Off when printing
on labels!
The Forms Tear-Off feature automatically moves
continuous-form paper up to the tear position after the
interval you select, then moves it back down again for
printing when the printer receives more data.
This feature is normally turned off. To activate it:
Ê
Ë
SEL
LF
SEL
Micro Feed
SHIFT
MENU
Down
EXIT GROUP
POWER ALARM
1. Press (Ë) +
SHIFT SEL
2. Press (Ì) until one of the following lines ap-
GROUP
pears, depending on which paper feed you are using:
REAR FEED Form Tear-Off
BOTTOM FEED Form Tear-OFF
E-34 Section 3
Ì Í
FF/LOAD TEAR PARK QUIET
Micro Feed
TOF
Up
ITEM SET PRINT
MENU
(Ê).
OFF
O F F
3. Press (Í) until the time interval you wish to select
SET
appears in the third column.
4. Press (Ë) +
SHIFT SEL
the setting.
Note: Some programs pause occasionally while sending
data. If the pause is too long, the paper will
advance to the tear-off position until more data is
received. This extra paper movement can cause
uneven print registration in graphics. If you have
this problem, use the menu to turn off this feature.

Paper Park Feature

SEL
LF
SEL
Micro Feed
SHIFT
MENU
Down
EXIT GROUP
POWER ALARM
To retract rear-feed paper form the paper path, press
(Ê).
(Ê) to exit Menu Mode and save
FF/LOAD TEAR PARK QUIET
Micro Feed
TOF
Up
PRINT
ITEM SET
MENU
Ê
PARK