To switch from single-sheet feed to continuous forms:
1. Press
to remove the single-sheet paper.
FF/LOAD
2. Lower the paper separator into the continuous-forms
position and swing the wire feed guide over onto the
pull-up roller.
3. Move the paper lever to the position marked "REAR" or
"BOT," as appropriate.
4. If necessary, load continuous-form paper.
5. Press
.
FF/LOAD
Setting the Printhead Gap
The printhead gap is the distance between the printhead
and the platen.
Note: Make sure the printer is turned off before you
open the access cover.
To adjust the gap, open the access cover and move the blue
lever (Ê) to the recommended setting from the table.
E-10 Section 1
Ê
Media
12-20 lb paper ............................ 1
20-24 lb bond paper ................... 2
Labels ........................................ 3-4
Envelopes .................................. 4-5
2-part form (with carbon) ........... 1-2
3-part form (with carbon) ........... 2-3
4-part form (with carbon) ........... 3-4
5-part form (with carbon) ........... 4-5
6-part form (with carbon) ........... 5
Setting