Table of Contents
Advertisement
Performer 2500 Fresnel Tungsten
Mode 2
In this menu you can set the dimmer, CCT and the dimming curve.
01) Turn the controls (D/E/F) to adjust settings.
The adjustment ranges are:
●
D: Dimmer, from dark to brightest (0–100 %)
●
E: CCT (2700 K, 3000 K, 3200 K, 3400 K, 3600 K, 3800 K, 4000 K, 4200 K, 4500 K)
●
F: Dimming curve (OFF, CV1, CV2, CV3)
Once you have set your settings, press each of the controls (D/E/F) to save your settings. Otherwise,
your settings will be lost upon returning to the previous menu.
Static
In this menu, you can set the static colors (WW: warm white; NW: natural white).
01) Press the UP/DOWN buttons to scroll through the static colors (WW, NW) and STROBE.
Press the ENTER button to open the settings submenu.
Press the UP/DOWN buttons to increase/decrease the values.
●
Color intensity (WW, NW): the adjustment range is between 0–255, from low to high intensity
●
STROBE frequency: the adjustment range is between 0–25, from OFF to high frequency
Press the ENTER button to set the value and to move to the next setting.
DMX Address
In this menu you can set the device's DMX starting address.
01) Press the UP/DOWN buttons to set the desired DMX address. The adjustment range is 001–512.
02) Press the ENTER button to save the changes.
Run Mode
In this menu you can set the control mode of the device.
01) Press the UP/DOWN buttons to toggle between the following 2 options:
●
DMX: the device will operate in DMX Mode.
●
SLAVE: the device will operate as a slave in Master/Slave Mode. It means that it will react the
same as the master device.
Press the ENTER button to confirm your choice.
Product code: 33141
26
Advertisement
Table of Contents
