Table of Contents
Advertisement
Airstrike
Control Modes
There are 5 modes:
One Airstrike (Auto run mode and Sound-controlled mode)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Airstrike is not connected with a DMX cable, it functions as a stand-alone device.
05) Please see page 14-15 for more information.
One Airstrike (Manual Mode)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Airstrike is not connected with a DMX-cable, it functions as a stand-alone device.
05) Please see page 16 for more information about the Manual mode.
Multiple Airstrikes (Master / Slave Control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 3-pin XLR cable to connect the Airstrikes.
The pins:
05) Link the units as shown in (fig.04). Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. This means
that you can set your desired operation mode on the master device and all slave devices will react
the same as the master device.
Multiple Airstrikes (Master / Slave Set Up)
Ordercode: 43158
Auto run mode
Manual mode
Sound-controlled mode
Master / Slave
DMX-512 (10CH)
01) Earth
02) Signal (-)
03) Signal (+)
9
Fig. 04
Advertisement
Table of Contents
