Main Meter (Hz); Div. Parameters 1; Hysteresis; Switching Interval - janitza Procont-LMC User Manual And Technical Data

Procont -LMC | Procont
®
14.3

Main meter (HZ):

Selection of the main meters.
With the Procont -LMC, several meters can be
®
selected.
Name Default
+/- +
IO1, IO2, ... IO2
Lk Lk
14.4

Div. parameters 1

14.4.1

Hysteresis:

The switching hysteresis between the switch-on
and switch-off characteristic curve is automatically
adjusted to the set target power and can be set to
between 0 % and 9 %. (default setting 3 %).
14.4.2

Switching interval:

The time between the disconnection of 2 consum-
ers (groups), when the disconnection of the first
consumer brought no or too little power reduction.
14.4.3

!LG reset

Load group reset on restart. All load groups are
reactivated after the end of the measuring period.
14.4.4

12 setpoints:

Activates the 12 monthly setpoints. A setpoint can
be entered here for each month. In addition, each
month can be divided into "HT" and "NT".
14.4.5

Div. parameters 2

· Number of load groups
· Setting the existing load groups.
The number of consumer groups switched off by
the Procont -LMC/Procont
®
here. There are 8 preset load groups in the default
setting. If you want to set and switch off more than
8 consumers (consumer groups), corresponding
expansion modules for 8 consumers (consumer
groups) each must be connected.
36
-LMC-LITE
®
Setting Description
+ or - The following meter is added or subtracted
IO1, IO2, ... P+ Meter of the selected controller:
Lk, 01, 02, ... Station number from which the specified meter is used
Lk = local meter
01, 02, ... Station number of the substation
-LMC-LITE can be set
®
www.janitza.de