Installation; Warnings - Pentair E-Box SOLEO Connect Installation And Operation Manual

Installation and Operation Guide Version E-Box SOLEO Connect - Installation
4

Installation

4.1

Warnings

CAUTION
Risk of injury due to electric shock or pressurised elements!
It is strictly forbidden for any unqualified personnel to access the internal components of
the system in order to carry out any technical work whatsoever.
• Check that the power supply is switched off. Close the water inlet and relieve the
system of pressure before opening the hood to access the internal components.
Mandatory
The equipment is permanently connected.
Mandatory
The equipment must be installed by a qualified technician according to the local
regulations in force.
Info
Each output has a normally open dry contact for a maximum voltage of 230 V.
The manufacturer is not responsible for any personal injury or material damage resulting from
improper use of the device or any use thay is not in accordance with the following instructions.
In case of any doubt in this manual regarding installation, operation or maintenance, please
contact the technical support of the company that installed the device.
The installation of the device must be carried out by a qualified technician in compliance with the
standards and regulations in force, using tools compatible with the device for safe use. This same
technician must also ensure the maintenance of the device.
In the event of a failure or malfunction, before performing any repair work on the device, ensure
that the E-Box SOLEO Connect is disconnected from the power supply:
1. Be careful when unpacking and during subsequent handling, as the weight is likely to cause
property and personal injury in the event of an accidental impact.
2. Before any electrical connection, earth the installation.
3. Ensure that the environment in which the appliances are installed does not reach
temperatures that may cause the water to freeze, as the valve may be damaged.
20 / 64 Ref. SB-CU-IMP-069EB / A - 12.05.2023