E-Box; Wall Mounting - Pentair E-Box SOLEO Connect Installation And Operation Manual

Installation and Operation Guide Version E-Box SOLEO Connect - Installation
4.5

E-Box

4.5.1

Wall mounting

Tools Required for Installation
You will need the following tools in order to perform the installation in the best possible
conditions:
• Flat Screwdriver Set
• Drill Bit Set
• One tape measure
• One level
Caution - material
The device must not be installed outdoors, preferring instead a technical room
inaccessible to children.
• Ensure that the bracket on which the appliance is installed can support a load of
10 kg.
• Use dowels suitable for the bracket on which the enclosure is to be installed.
ü The casing should rests on a workbench.
1. Unscrew the twelve screws (2).
2. Remove the two covers (3).
3. Use a drill to make four holes (1).
1
Tip
It is advisable to drill the holes (1) of the four corners of theE-Box (6).
Otherwise, take into account the centre of gravity of the E-Box in order to determine the
position of the holes.
4. Mark the four holes (4) to be drilled in the wall.
5. Drill through the wall at the previously marked locations.
28 / 64
3
2
Ref. SB-CU-IMP-069EB / A - 12.05.2023