Soleo And Speedeo Connect; Wall Mounting - Pentair E-Box SOLEO Connect Installation And Operation Manual

4.6

Soleo and Speedeo Connect

4.6.1

Wall mounting

Caution - material
The device must not be installed outdoors, preferring instead a technical room
inaccessible to children.
• Ensure that the bracket on which the appliance is installed can support a load of
5 kg.
• Use dowels suitable for the bracket on which the enclosure is to be installed.
Info
The installation procedure below is valid for the boxes SOLEO and SPEEDEO Connect.
1. Mark the three holes to be drilled in the wall according to the dimension (5) indicated behind
the device (2).
2. Drill through the wall at the previously marked locations.
3. Insert one dowel into each hole.
4. Install the upper screw (1) and hang the device (2) in the place provided for this purpose.
5. Secure the appliance (2) using the two bottom screws (4).
6. Install the two covers (3) of the screws in order to ensure the tightness of the device (2).
Info
The quick-connect cables are connected to the bottom of the appliance (2).
Install the cable ducts and plugs with the supplied silicone grease.
Cable ducts and plugs prevent the entry of moisture or acid vapour into the appliance.
Never leave an empty hole unused without protection. See Chapter Connections
[ → Page 42].
Ref. SB-CU-IMP-069EB / A - 12.05.2023
Installation and Operation Guide Version E-Box SOLEO Connect - Installation
1
2
5
3
4
37 / 64