Chapter 6 Ups Operating Instructions; Ups Control Panel And Indicator Lamps; Control Panel - Santak CASTLE Series User Manual

Chapter 6
This section will introduce how to use the color touch screen to operate the UPS.
See Section 6.1 or Section 6.2 for the relevant information.
NOTE
• Before UPS startup, please make sure that all installation work has been completed, and that the
initial startup has been performed by Santak's customer service engineers. Before the initial startup,
check all electrical connections to ensure successful installation and normal operation of the
system.
• Read this part of information in this manual before operating any control devices, and have a full
understanding of UPS operations.
• The UPS can work at any of the following three rated voltages: 220/380,230/400 or 240/415VAC.
Before UPS operation, confirm the rated voltage and frequency of the UPS via the Settings ->
System Information on the screen. If the UPS has to work at other voltages or frequencies, please
contact the nearest Santak office or the Santak authorized dealer.
• The UPS is not a measurement device. All measurements displayed are approximate values.

6.1. UPS Control Panel and Indicator Lamps

This section introduces the control panel and indicator lamps of the UPS, which is used for controlling and
monitoring the UPS operations. Shown in
6.1.1.

Control Panel

The control panel is used to set up and control the UPS, and to monitor UPS operation. For a
description of the UPS control panel functions, see Section
Copyright © 2022 Santak Corporation plc. All rights reserved.
UPS OPERATING INSTRUCTIONS
Figure 6-1
Installation and Operation Manual
are the UPS control panel and indicator lamps.
6.2 .
Santak 3C3 HD 20-80 kW UPS
46