Santak CASTLE Series User Manual page 12

• Do not open or disassemble the batteries. The released electrolyte may be toxic, which may harm the
skin and eyes.
• Important: If there are more than one batteries connected in parallel, the UPS must be disconnected
from all batteries before installation.
• The UPS can only be installed on concrete or nonflammable surface.
CAUTION
• Installation or servicing should be performed by qualified service personnel knowledgeable of
batteries and required precautions. Keep unauthorized personnel away from batteries. Consider all
warnings, cautions, and notes before installing or replacing batteries. DO NOT DISCONNECT the
batteries while the UPS is in Battery Mode.
• Please read the installation instructions before connecting to the power source.
• Check whether any battery is accidentally grounded. If any, remove the grounded power supply. An
electric shock may be caused by touching any part of a grounded battery.
• For battery replacement, use batteries of the same type and specifications as those originally used
in the UPS system.
• Disconnect the charging power supply before connecting or disconnecting terminals.
• Dispose of used batteries properly. Refer to the local disposal regulations.
• Do not throw the battery into a fire, as it may explode.
• Keep the UPS door closed to maintain appropriate cooling air flow. This can also protect the
operators from being injured by hazardous voltage inside the equipment.
• Never operate the UPS system near any source of gas or electrical heat.
• Keep the operating environment within the parameters specified in this manual.
• Follow all "Danger", "Attention" and "Instructions" warnings affixed to the inside and outside of the
equipment.
CAUTION
To prevent damage to the wiring channel and wiring in the UPS cabinet base when lifting or moving the
cabinet:
• Use only the left or right forklift slot to lift and move a packed cabinet.
• Make sure that the forklift fork is inserted into the forklift slot at the horizontal position. Do not tilt
the fork upwards.
• Insert the forks all the way through the base.
Damage to the wiring channels and wiring may be caused by failure to comply with these instructions.
1
Copyright © 2022 Santak Corporation plc. All rights reserved.