Removing The Etco Sensor Kit; Check Before And After Use; Cleaning And Disinfection - Progetti Rescue Life 9 Instructions For Use Manual

3 – ACQUISITION OF BIOMEDICAL PARAMETERS
3.3.4. REMOVING THE ETCO
When removing the CO
and hold the CO sensor straight up with the index finger and middle finger.
2

3.3.5. CHECK BEFORE AND AFTER USE

To use the CO sensor kit safely and properly, check the following items:
2
•
No scratches, damage or dirt on the CO
•
No fluid or blood on the CO
•
No dirt on the photo detector and light emitter on the CO
airway adapter
•
Airway adapter is not damaged or deformed

3.3.6 CLEANING AND DISINFECTION

Rescue Life
SENSOR KIT
2
CAUTION - When removing the CO
side of the sensor. The cable may break or excessive force may damage the CO
sensor.
sensor from the airway adapter, hold the respiration circuit firmly with one hand
2
2
sensor kit and cables
2
CAUTION - Do not use corrosive solutions or solutions with polishing
agents.
CAUTION - Do not clean the CO
because it scratches the sensor and causes incorrect measurement.
CAUTION - Do not use volatile liquids such as thinner, benzine or
industrial alcohol because these damage the sensor surface.
9
– Instruction For Use
sensor, do not hold the cable or one
2
sensor kit and cables
sensor and transparent film on the
2
sensor with steel wool or sharp objects
2
3-26
Rev.0.5 – 30/03/2022
2