Table of Contents
Advertisement
1.5.4 POSSIBLE IMPROPER DEVICE PERFORMANCE
Using other manufacturers' cables, electrodes, or batteries may cause the device to perform improperly
and may invalidate the safety agency certifications. Use only the accessories that are specified in these
operating instructions.
1.5.5 POSSIBLE DEVICE SHUTDOWN OR NOT SWITCHING ON
Always check that the battery is fully charged.
IF A BATTERY LOW MESSAGE APPEARS ON THE MONITOR SCREEN
.
TO AN OUTLET
1.5.6 ELECTRICAL SAFETY GUIDELINES
Use only the original power cord during recharging.
The right value for the AC power supply is: 100 - 240 V
During recharging, do not place the device where the environmental conditions exceed the storage
conditions specified.
D
URING OPERATION
,
MOTORS
GENERATORS
INTERFERE WITH THE SIGNALS BEING ACQUIRED
The RESCUE LIFE 9 is classified as follows:
•
Class II equipment;
•
Applied parts:
o Type Defibrillation-proof BF for Defibrillation electrodes, SpO2 module, NIBP module,
TEMP module, EtCO
o Type Defibrillation-proof CF for ECG module;
•
The Electromagnetic compatibility level is Class B group 1 according to the EN 60601-1-2
(Electromagnetic Compatibility Requirements).
Rescue Life
1 - INTRODUCTION
,
THE DEVICE SHOULD BE PLACED AWAY FROM SOURCES OF ELECTROMAGNETIC INTERFERENCE SUCH AS
,
-
,
X
RAY EQUIPMENT
RADIO TRANSMITTERS
.
module
2
9
– Instruction For Use
,
THE OPERATOR HAS TO CONNECT IMMEDIATELY THE AC POWER CORD
, 50 - 60 Hz.
AC
,
CELLULAR MOBILE TELEPHONES AND OTHERS
1-29
Rev.0.5 – 30/03/2022
,
AS THESE MIGHT
Advertisement
Table of Contents
