Table of Contents
Advertisement
3 – ACQUISITION OF BIOMEDICAL PARAMETERS
3.2.1 PROCEDURE
1.
Insert SpO2 SENSOR's connector in SpO2 PORT, as shown in the follow picture:
SpO2 SENSOR
Apply
2.
Read measures on the display's SpO2 box: "%" and "BPM".
3.
If only one ECG lead is set to show on the display ("PADS" for example) then SpO2 waveform (yellow)
is shown on the display automatically. About 10 seconds from the application to the patient's finger
are needed to view the stable waveform.
9
Rescue Life
to patient's finger, as shown in the follow picture.
3-17
– Instruction For Use
Rev.0.5 – 30/03/2022
Advertisement
Table of Contents
