Setting Up The Rescue Sam Aed; Overview; Installing And Removing The Battery Pack - Progetti RESCUE SAM User Manual

3

Setting up the RESCUE SAM AED

This chapter describes the steps required to make your Progetti Srl RESCUE SAM AED operational. The
RESCUE SAM is designed to be stored in a "ready" state. This chapter tells you how to make the device
ready, so that if and when you need it, few steps are required to begin using the device.
3.1

Overview

The following components and accessories are included with your RESCUE SAM. Replacement and other
accessories are detailed in the "RESCUE SAM Accessories" section. Before getting started, identify each
component and ensure that your package is complete
RESCUE SAM and
Battery pack
3.2

Installing and Removing the Battery Pack

The lithium battery pack provides power to the RESCUE SAM.
Do not install the battery pack after the expiration date printed on the label. The battery pack is non-
rechargeable.
To insert the battery pack into the RESCUE SAM, orient the battery pack so that the label faces up. Make
certain that the battery opening in the side of the AED is clean and clear of any foreign objects. Insert
the battery pack into the opening in the side of the AED. Slide the pack all the way in until the latch
clicks. If the pack does not slide all the way in, it is most likely inserted upside down.
inserted, the battery pack surface should be flush with the side of the AED.
To remove the battery pack, push the battery release lever and pull the battery pack out.
After battery insertion the RESCUE SAM runs an automatic self test that verifies the readiness for rescue
operation. Upon passing the self test the status green LED will flash. If the self test does not pass the
status red LED will flash.
RESCUE SAM User Manual vers.1.0 Jun. 2015
.
User Manual
Defibrillation pads
Once fully
9