Table of Contents
Advertisement
S
S
UPER
ERVER 5013G-M Manual
1.5V 4xAGP Slot
The 4xAGP slot is included on the P4SGE.
You should first disable the
integrated video in BIOS before adding a VGA card to this slot. (See the
"On-Chip VGA" setting in the Advanced Chipset Features section in BIOS.)
The 4xAGP slot is backward compatible with 2xAGP graphics cards.
To install a VGA card, power down the system and remove the I/O shield
corresponding to the AGP slot. Then, pull back the locking tab on the slot
before inserting your VGA card.
After the card is inserted, close the
locking tab if possible (some VGA cards have a notch in the corner of the
board to lock it into place, others do not.)
Replace all chassis covers
before restoring power to the system.
5-22
Advertisement
Table of Contents
