Table of Contents
Advertisement
S
S
UPER
ERVER 5013G-M Manual
Figure 6-3.
6-4
Drive Bay Installation/Removal
Accessing the Drive Bays
CD-ROM/IDE/Floppy Disk Drives: For installing or removing the CD-ROM, IDE
or floppy disk drives, you will need to gain access to the inside of the
5013G-M by removing the top cover of the chassis.
Note: Only a "slim" CD-ROM drive and a "slim" floppy drive will fit in the
5013G-M.
IDE Drive Installation
1.
Installing/removing an IDE drive
The IDE drive bay is located in the front of the chassis, making it easily
accessible for installation and removal. The IDE drive is not hot-swappable,
meaning system power must be turned off before installing and/or removing
one.
To install or remove the drive, first power down the system and then remove
the top cover of the chassis. Unscrew the retention screw at the top
center of the drive, then push the drive tray out from the back until you can
grasp and pull it out through the front of the chassis. Remove the drive
from the drive tray.
Replacing the System Cooling Fan
6-4
Advertisement
Table of Contents
